What builds up inside a water heater
Every gallon of water that passes through a tank leaves a little mineral behind. Over time it settles on the bottom as a layer of sediment. The burner or elements have to heat through that layer, so the heater works harder, the tank can pop and rumble, and you can get less hot water than you used to.
Inside the tank, a sacrificial anode rod corrodes in place of the steel. It's the main thing standing between the tank and rust. Once the rod is spent, the tank itself starts to corrode, and a corroded tank can't be repaired.
What tank maintenance covers
A typical visit for a tank water heater includes these steps.
Draining and flushing
We drain water from the bottom of the tank to carry the sediment out, then refill it.
Anode rod inspection
We check how much of the rod is left. A worn rod can be replaced before the tank starts to rust.
Relief valve test
The temperature and pressure relief valve is a safety device. We check that it opens and reseats properly.
Burner, pilot or elements
On gas units we check the burner and pilot; on electric units, the heating elements and thermostats.
Venting and gas connections
On gas units we check that the flue vents properly and that the gas connections are sound.
Connections and the tank
We look for drips at the fittings and valves, and for rust or moisture on and under the tank.
Tankless water heaters need care too
A tankless unit has no tank to collect sediment, but minerals still build up as scale inside its heat exchanger. Scale makes the unit work harder and can trigger error codes or uneven water temperature.
Maintenance for a tankless unit means flushing the heat exchanger with a descaling solution, cleaning the inlet water filter, and checking the venting, the burner and the error history. Many units have service valves built in for exactly this.
Signs it's time for maintenance
Popping or rumbling
That sound is water trapped under a layer of sediment, boiling as the burner fires.
Less hot water than before
Sediment takes up room in the tank and gets in the way of heating.
Rusty or cloudy hot water
Discolored hot water can point to a spent anode rod or sediment stirred up from the bottom.
Temperature swings on a tankless unit
Scale in the heat exchanger can make the water run hot and cold, or set off error codes.
How often to schedule
Once a year is common advice for both tank and tankless heaters. A household that uses a lot of hot water, or a home with hard water, may need it more often. If you're not sure when yours was last serviced, that's a good reason to have it looked at now.
Between visits, keep the area around the heater clear, glance at the base of the tank now and then for moisture, and call if you notice any of the signs above.
If we find a problem
We explain what we found and what your options are. Customers know and approve the cost before work begins. If the tank itself is failing, you'll hear that plainly, along with the choices for a new one.
Comfort Air Control is a family business based in Northbrook. We maintain water heaters across 28 North Shore and northwest-suburban towns and service all makes and models. Call or text (224) 805-0861.
Water Heater Maintenance: common questions
Why is my water heater making a popping noise?
Popping or rumbling usually means sediment has built up on the bottom of the tank, and water trapped under it is boiling as the burner heats. Flushing the tank usually quiets it.
How often should a water heater be flushed?
Once a year is common advice. Homes with hard water or heavy hot water use may need it more often.
What is an anode rod?
A metal rod inside the tank that corrodes so the tank doesn't. Checking it during maintenance, and replacing it when it's worn, helps protect the tank from rust.
Do tankless water heaters need maintenance?
Yes. Minerals build up as scale inside the heat exchanger, so tankless units need periodic descaling and a check of the inlet filter and venting.